enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Micro ribbon connector - Wikipedia

   en.wikipedia.org/wiki/Micro_ribbon_connector

   The micro ribbon or miniature ribbon connector is a common type of electrical connector for a variety of applications, such as in computer and telecommunications equipment having many contacts. The connector contains two parallel rows of contacts within a shielded case having a characteristic D-shape similar to that used in D-subminiature ...

3. Ribbon cable - Wikipedia

   en.wikipedia.org/wiki/Ribbon_cable

   Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).

4. Floppy disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Floppy_disk_drive_interface

   A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally a ribbon cable. For IBM-compatible floppy controllers, a twist in the cable reverses the order of conductors 10 through 16 for the second connector.

5. SCSI connector - Wikipedia

   en.wikipedia.org/wiki/SCSI_connector

   One such in somewhat common use was the VHDCI (Very High Density Cable Interconnect) connector, also known as an "AMP HPCN68M", and sometimes as "SCSI-5". There are 68 pins on the connector in two rows; the pins are 0.8 mm apart. This connector is reputed to suffer fewer bent pins than the 68-pin SCSI-2 connector despite its minuscule pins.

6. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

7. Sol-20 - Wikipedia

   en.wikipedia.org/wiki/Sol-20

   Originally, expansion was going to be handled through an external cage that connected to the main console using two 50-pin ribbon cables. The original Altair bus design lacked signal ground pins for each of its data lines, a decision that had been made in order to reduce pin count and allow it to fit into 100-pin connectors they found in surplus.

8. 25-pair color code - Wikipedia

   en.wikipedia.org/wiki/25-pair_color_code

   A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.

9. Parallel ATA - Wikipedia

   en.wikipedia.org/wiki/Parallel_ATA

   Round parallel ATA cables (as opposed to ribbon cables) were eventually made available for 'case modders' for cosmetic reasons, as well as claims of improved computer cooling and were easier to handle; however, only ribbon cables are supported by the ATA specifications. Pin 20 In the ATA standard, pin 20 is defined as a mechanical key and is ...