Ads
related to: 2.1 mm to inches fraction chart
Search results
Results from the WOW.Com Content Network
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
32 gauge — .526 in (13.4 mm) 28 gauge — .550 in (14.0 mm) 24 gauge — .579 in (14.7 mm) 20 gauge — .615 in (15.6 mm) 16 gauge — .663 in (16.8 mm) 14 gauge — .693 in (17.6 mm) 12 gauge — .729 in (18.5 mm) 10 bore — .775 in (19.7 mm) 8 bore — .835 in (21.2 mm) 6 bore — .919 in (23.3 mm) 4 bore — 1.052 in (26.7 mm)
Last, multiply the original expression of the physical value by the fraction, called a conversion factor, to obtain the same physical value expressed in terms of a different unit. Note: since valid conversion factors are dimensionless and have a numerical value of one , multiplying any physical quantity by such a conversion factor (which is 1 ...
Most standard size SD cards are 2.1 mm (0.083 inches) [58] thick, with microSD versions being 1.0 mm (0.039 inches) [58] thick, compared to 1.4 mm (0.055 inches) for MMCs. The SD specification defines a card called Thin SD with a thickness of 1.4 mm, [citation needed] but they occur only rarely, as the SDA went on to define even smaller form ...
Length of an average flea is 1–10 mm (usually <5 mm) [27] 2.54 mm One-tenth inch; distance between pins in DIP (dual-inline-package) electronic components 5.70 mm Diameter of the projectile in 5.56×45mm NATO ammunition 10 −2: 1 centimeter 20 mm Approximate width of an adult human finger: 54 mm × 86 mm
Thickness of aluminum foil is measured in mils (1 ⁄ 1000 inch, or 0.0254 mm) in the United States. Cross-sectional area of electrical wire is measured in circular mils in the U.S. and Canada, one circular mil (cmil) being equal to 5.067 × 10 −4 mm 2 (or 7.854 × 10 −7 in 2). Since this is so small, actual wire is commonly measured in ...
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
Ads
related to: 2.1 mm to inches fraction chart