Search results
Results from the WOW.Com Content Network
HDPE is known for its high strength-to-density ratio. [4] The density of HDPE ranges from 930 to 970 kg/m 3. [5] Although the density of HDPE is only marginally higher than that of low-density polyethylene, HDPE has little branching, giving it stronger intermolecular forces and tensile strength (38 MPa versus 21 MPa) than LDPE. [6]
Consider a beam whose cross-sectional area increases in two dimensions, e.g. a solid round beam or a solid square beam. By combining the area and density formulas, we can see that the radius of this beam will vary with approximately the inverse of the square of the density for a given mass.
For medium- and high-density polyethylene the melting point is typically in the range 120 to 130 °C (248 to 266 °F). The melting point for average commercial low-density polyethylene is typically 105 to 115 °C (221 to 239 °F).
The kilogram per cubic metre (symbol: kg·m −3, or kg/m 3) is the unit of density in the International System of Units (SI). It is defined by dividing the SI unit of mass, the kilogram, by the SI unit of volume, the cubic metre. [1]
EPE foams are low density, semi-rigid, closed cell foam that are generally somewhere in stiffness/compliance between Expanded polystyrene and Polyurethane. Production of EPE foams is similar to that of expanded polystyrene, but starting with PE beads. [1] Typical densities are 29 to 120 kg/m 3 (49 to 202 lb/cu yd) with the lower figure being ...
As there are many units of mass and volume covering many different magnitudes there are a large number of units for mass density in use. The SI unit of kilogram per cubic metre (kg/m 3) and the cgs unit of gram per cubic centimetre (g/cm 3) are probably the most commonly used units for density. One g/cm 3 is equal to 1000 kg/m 3. One cubic ...
The SI unit for specific strength is Pa⋅m 3 /kg, or N⋅m/kg, which is dimensionally equivalent to m 2 /s 2, though the latter form is rarely used. Specific strength has the same units as specific energy , and is related to the maximum specific energy of rotation that an object can have without flying apart due to centrifugal force .
Medium-density polyethylene (MDPE) is a type of polyethylene defined by a density range of 0.926–0.940 g/cm 3. [1] It is less dense than HDPE, which is more common. MDPE can be produced by chromium/silica catalysts, Ziegler-Natta catalysts or metallocene catalysts. MDPE has good shock and drop resistance properties.