Search results
Results from the WOW.Com Content Network
Having a constant diameter, measured at varying angles around the shape, is often considered to be a simple measurement of roundness.This is misleading. [3]Although constant diameter is a necessary condition for roundness, it is not a sufficient condition for roundness: shapes exist that have constant diameter but are far from round.
Horizontal distance = cos (inclination) × slope distance. The help of an assistant or the use of a laser rangefinder can greatly speed this process. When using a laser rangefinder, as in measuring tree height, several points on the far edge of the crown can be explored to find the furthest point.
The equilateral cylinder is characterized by being a right circular cylinder in which the diameter of the base is equal to the value of the height (geratrix). [ 4 ] Then, assuming that the radius of the base of an equilateral cylinder is r {\displaystyle r\,} then the diameter of the base of this cylinder is 2 r {\displaystyle 2r\,} and its ...
Radius of gyration (in polymer science)(, unit: nm or SI unit: m): For a macromolecule composed of mass elements, of masses , =1,2,…,, located at fixed distances from the centre of mass, the radius of gyration is the square-root of the mass average of over all mass elements, i.e.,
[28] [29] The volume of the trunk is expressed as a percentage of the volume of a cylinder that is equal in diameter to the trunk above basal flare and with a height equal to the height of the tree. A cylinder would have a percent cylinder occupation of 100%, a quadratic paraboloid would have 50%, a cone would have 33%, and a neiloid would have ...
The radius or radial distance is the Euclidean distance from the origin O to P. The inclination (or polar angle) is the signed angle from the zenith reference direction to the line segment OP. (Elevation may be used as the polar angle instead of inclination; see below.)
The radial distance ρ is the Euclidean distance from the z-axis to the point P. The azimuth φ is the angle between the reference direction on the chosen plane and the line from the origin to the projection of P on the plane. The axial coordinate or height z is the signed distance from the chosen plane to the point P.
t is the radial thickness of the cylinder; l is the axial length of the cylinder. An alternative to hoop stress in describing circumferential stress is wall stress or wall tension (T), which usually is defined as the total circumferential force exerted along the entire radial thickness: [3] = Cylindrical coordinates