Search results
Results from the WOW.Com Content Network
The damaged transistor shows a low-ohmic junction between gate and drain terminals. A parametric failure only shifts the device parameters and may manifest in stress testing; sometimes, the degree of damage can lower over time. Latent ESD failure modes occur in a delayed fashion and include: Insulator damage by weakening of the insulator ...
Reverse bias: Although the LED is based on a diode junction and is nominally a rectifier, the reverse-breakdown mode for some types can occur at very low voltages and essentially any excess reverse bias can cause immediate degradation, and may lead to vastly accelerated failure. 5 V is a typical maximum reverse bias voltage specification for ...
Computer monitors are typically packed into low stacks on wooden pallets for recycling and then shrink-wrapped. [1]Electronic waste recycling, electronics recycling, or e-waste recycling is the disassembly and separation of components and raw materials of waste electronics; when referring to specific types of e-waste, the terms like computer recycling or mobile phone recycling may be used.
This allows all light to pass through to the RGB layer, creating a bright pixel that is always on. Another cause of bright dot may be the presence of impurities in the liquid crystal. On the one hand, impurities will affect the alignment of liquid crystal molecules, and on the other hand, they can reflect light to form bright spots.
When optical fibers are exposed to ionizing radiation such as energetic electrons, protons, neutrons, X-rays, Ƴ-radiation, etc., they undergo 'damage'. [1] [2] The term 'damage' primarily refers to added optical absorption, resulting in loss of the propagating optical signal leading to decreased power at the output end, which could lead to premature failure of the component and or system.
If the filter fails to capture a dust particle, the particle can land on the platter, causing a head crash if the head happens to sweep over it. After a head crash, particles from the damaged platter and head media can cause one or more bad sectors. These, in addition to platter damage, will quickly render a drive useless.
For example, an electric light bulb has a wire in it that at the given rated voltage will carry a current just large enough for the wire to get very hot (giving off light and heat), but not hot enough for it to melt. The amount of current in a circuit depends on the voltage supplied: if the voltage is too high, then the wire may melt and the ...
The wires are usually inserted into a plastic base that the bulb is mounted in, and which is often narrower at the tip than at the bulb, giving it a wedge shape and usually ensuring a tight connection, depending on manufacturing tolerances. Some bulbs have no plastic base, and the wires are simply bent up to the sides of the bulb's glass base.