Search results
Results from the WOW.Com Content Network
Blasting mats are used when explosives are detonated in places such as quarries or construction sites. The mats are placed over the blasting area to contain the blast, suppress noise [1] and dust as well as prevent high velocity rock fragments called fly rock (or flyrock) from damaging structures, [2] people or the environment in proximity to the blast site. [3]
Pages in category "Abrasive blasting" The following 8 pages are in this category, out of 8 total. This list may not reflect recent changes. A. Abrasive jet machining; D.
Sand blasting is also known as abrasive blasting, which is a generic term for the process of smoothing, shaping and cleaning a hard surface by forcing solid particles across that surface at high speeds; the effect is similar to that of using sandpaper, but provides a more even finish with no problems at corners or crannies.
Rock blasting in Finland. Drilling and blasting is the controlled use of explosives and other methods, such as gas pressure blasting pyrotechnics, to break rock for excavation. It is practiced most often in mining, quarrying and civil engineering such as dam, tunnel or road construction. The result of rock blasting is often known as a rock cut.
Match type blasting caps use an electric match (insulating sheet with electrodes on both sides, a thin bridgewire soldered across the sides, all dipped in ignition and output mixes) to initiate the primary explosive, rather than direct contact between the bridgewire and the primary explosive. The match can be manufactured separately from the ...
Silicate and aluminate impurities from the ore and coke are combined in the blast furnace with a flux which lowers the viscosity of the slag. In the case of pig iron production, the flux consists mostly of a mixture of limestone and forsterite or in some cases dolomite. In the blast furnace the slag floats on top of the iron and is decanted for ...
Abrasive jet machining (AJM), also known as abrasive micro-blasting, pencil blasting and micro-abrasive blasting, [1] is an abrasive blasting machining process that uses abrasives propelled by a high velocity gas to erode material from the workpiece. Common uses include cutting heat-sensitive, brittle, thin, or hard materials.
The method is similar to other forms of media blasting such as sand blasting, plastic bead blasting, or sodablasting in that it cleans surfaces using a medium accelerated in a pressurized air stream, but dry-ice blasting uses dry ice as the blasting medium. Dry-ice blasting is nonabrasive, non-conductive, nonflammable, and non-toxic.