Search results
Results from the WOW.Com Content Network
The slope of the water table is known as the “hydraulic gradient”, which depends on the rate at which water is added to and removed from the aquifer and the permeability of the material. The water table does not always mimic the topography due to variations in the underlying geological structure (e.g., folded, faulted, fractured bedrock).
Condensation forming in the low pressure zone above the wing of an aircraft due to adiabatic expansion. Condensation is the change of the state of matter from the gas phase into the liquid phase, and is the reverse of vaporization. The word most often refers to the water cycle. [1]
In the following table, material data are given with a pressure of 611.7 Pa (equivalent to 0.006117 bar). Up to a temperature of 0.01 °C, the triple point of water, water normally exists as ice, except for supercooled water, for which one data point is tabulated here. At the triple point, ice can exist together with both liquid water and vapor.
The boiling point of water is the temperature at which the saturated vapor pressure equals the ambient pressure. Water supercooled below its normal freezing point has a higher vapor pressure than that of ice at the same temperature and is, thus, unstable. Calculations of the (saturation) vapor pressure of water are commonly used in meteorology.
His equation makes use of the relationship between the LCL and dew point temperature discussed above. In the Earth's atmosphere near the surface, the lapse rate for dry adiabatic lifting is about 9.8 K/km, and the lapse rate of the dew point is about 1.8 K/km (it varies from about 1.6-1.9 K/km). This gives the slopes of the curves shown in the ...
In technical terms, the dew point is the temperature at which the water vapor in a sample of air at constant barometric pressure condenses into liquid water at the same rate at which it evaporates. [7] At temperatures below the dew point, the rate of condensation will be greater than that of evaporation, forming more liquid water.
The convective condensation level (CCL) represents the height (or pressure) where an air parcel becomes saturated when heated from below and lifted adiabatically due to buoyancy. In the atmosphere, assuming a constant water vapor mixing ratio, the dew point temperature (the temperature where the relative humidity is 100%) decreases with ...
In the case of an equilibrium solid, such as a crystal, this can be defined as the pressure when the rate of sublimation of a solid matches the rate of deposition of its vapor phase. For most solids this pressure is very low, but some notable exceptions are naphthalene , dry ice (the vapor pressure of dry ice is 5.73 MPa (831 psi, 56.5 atm) at ...