Search results
Results from the WOW.Com Content Network
In the paint and coating industries, paint adhesion testing is often used to determine if the paint or coating will adhere properly to the substrates to which they are applied. Several tests measure the resistance of paints and coatings from substrates: cross-cut test, scrape adhesion, pull-off test, and others. [1] Cross Cut Tester
A test patch should be as clean as possible. Contamination of a patch can influence the results significantly. Bresle patch injected with 15ml water as in ISO 8502-6 Annex A. The ISO 8502-6 standard prescribes in annex A that certified patches shall be used. This annex describes a stress test to ensure patch adhesion and wash ability.
Toxicity characteristic leaching procedure (TCLP) is a soil sample extraction method for chemical analysis employed as an analytical method to simulate leaching through a landfill. The testing methodology is used to determine if a waste is characteristically hazardous, i.e., classified as one of the "D" listed wastes by the U.S. Environmental ...
In adhesion tests per ASTM D4541, in which an aluminum stud is bonded to the test surface and the stud is pulled in the direction normal to the surface, both surfaces of the failure interface were analyzed by X-ray photoelectron spectroscopy (XPS). F/C ratio was used as an indicator of the failure mode: F/C of zero corresponds to failure in the ...
The salt spray test (or salt fog test) is a standardized and popular corrosion test method, used to check corrosion resistance of materials and surface coatings.Usually, the materials to be tested are metallic (although stone, ceramics, and polymers may also be tested) and finished with a surface coating which is intended to provide a degree of corrosion protection to the underlying metal.
The Philippines' Bureau of Soils and Water Management (Filipino: Kawanihan ng Pamamahala sa Lupa at Tubig, [1] abbreviated as BSWM), is an agency of the Philippine government under the Department of Agriculture responsible for advising and rendering assistance on matters relative to the utilization of soils and water as vital agricultural resources.
Dye penetrant inspection (DP), also called liquid penetrate inspection (LPI) or penetrant testing (PT), is a widely applied and low-cost inspection method used to check surface-breaking defects in all non-porous materials (metals, plastics, or ceramics).
The notches are spaced 1/16 inch (1.6 mm) apart. The applicator bar is 5 inches (127 mm) wide and leaves 3 3/8 inches (86 mm) of applied coating behind after use. After the bar is drawn down the card with the coating, a series of parallel stripes with varying film thickness will be formed.