enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Marman clamp - Wikipedia

   en.wikipedia.org/wiki/Marman_clamp

   Aerospace pipe fittings with flanges for Marman clamps: a semi-rigid bleed air duct from a jet engine (left) and a semi-flexible fuel hose (right). A common use for Marman clamps is as quick-disconnect connectors in flexible aircraft fuel lines. [2]

3. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   Round duct is made using a continuous spiral forming machine which can make round duct in nearly any diameter when using the right forming die and to any length to suit, but the most common stock sizes range evenly from 4" to 24" (10-60 cm) with 6"-12" (15-30 cm) being most commonly used. Stock pipe is usually sold in 10' (300 cm) joints.

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Push-to-pull fittings are easily removed compression fitting that allows pipes to be connected with minimal tools. These fittings are similar to regular compression fittings but use an O-ring for sealing and a grip ring to hold the pipe. The main advantage is that it can easily be removed and re-used, it is easy to assemble, and the joints are ...

5. Ductile iron pipe - Wikipedia

   en.wikipedia.org/wiki/Ductile_iron_pipe

   EN 15655:2009 – Ductile iron pipes, fittings and accessories – Internal polyurethane lining for pipes and fittings – Requirements and test methods EN 877:1999/A1:2006 – Cast iron pipes and fittings, their joints and accessories for the evacuation of water from buildings – Requirements, test methods and quality assurance

6. Electrical conduit - Wikipedia

   en.wikipedia.org/wiki/Electrical_conduit

   Fittings for non-threaded conduits are either secured with set screws or with a compression nut that encircles the conduit. Fittings for general purpose use with metal conduits may be made of die-cast zinc, but where stronger fittings are needed, they are made of copper-free aluminum or cast iron. Couplings connect two pieces of conduit together.

7. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in 1 ⁄ 16-inch increments. Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness.