Search results
Results from the WOW.Com Content Network
As the address pushed to the stack is that of the aborted instruction rather than the contents of the program counter, executing an RTI (ReTurn from Interrupt) following an ABORT interrupt will cause the processor to return to the aborted instruction, rather than the next instruction, as would be the case with the other interrupts.
32-bit interrupt return. Differs from the older 16-bit IRET instruction in that it will pop interrupt return items (EIP,CS,EFLAGS; also ESP [j] and SS if there is a CPL change; and also ES,DS,FS,GS if returning to virtual 8086 mode) off the stack as 32-bit items instead of 16-bit items.
Signal handlers can instead put the signal into a queue and immediately return. The main thread will then continue "uninterrupted" until signals are taken from the queue, such as in an event loop. "Uninterrupted" here means that operations that block may return prematurely and must be resumed, as mentioned above.
If at that point entry (tail−1) is free (cleared), an interrupt will be generated (level interrupt) and the tail pointer will be incremented. If the hardware requires the interrupt be acknowledged, the CPU (interrupt handler) will do that, handle the valid DMA descriptors at the head, and return from the interrupt.
An end of interrupt (EOI) is a computing signal sent to a programmable interrupt controller (PIC) to indicate the completion of interrupt processing for a given interrupt. Interrupts are used to facilitate hardware signals sent to the processor that temporarily stop a running program and allow a special program, an interrupt handler, to run ...
In a computer, an interrupt request (or IRQ) is a hardware signal sent to the processor that temporarily stops a running program and allows a special program, an interrupt handler, to run instead. Hardware interrupts are used to handle events such as receiving data from a modem or network card , key presses, or mouse movements.
the segment selector in a call, interrupt or trap gate does not point to a code segment; violating privilege rules; enabling paging whilst disabling protection; referencing the interrupt descriptor table following an interrupt or exception that is not an interrupt, trap, or a task gate; Legacy SSE: Memory operand is not 16-byte aligned.
Message Signaled Interrupts (MSI) are a method of signaling interrupts, using special in-band messages to replace traditional out-of-band signals on dedicated interrupt lines. While message signaled interrupts are more complex to implement in a device, they have some significant advantages over pin-based out-of-band interrupt signalling, such ...