Search results
Results from the WOW.Com Content Network
Increasing the voltage [4] over the default 12 V can be achieved by e.g. connecting the −12 V or −5 V power line instead of the ground wire in the fan connector, and by connecting the 5 V power line in the +12 V input of the fan connector. Through this procedure, 10, 17 and 24 V voltages can be achieved, with voltages exceeding 12 V being ...
Connectors usually used for computer fans are the following: Three-pin Molex connector KK family This Molex connector is used when connecting a fan to the motherboard or other circuit board. It is a small, thick, rectangular in-line female connector with two polarizing tabs on the outer-most edge of one long side.
Most motherboards have connectors for additional computer fans and integrated temperature sensors to detect motherboard and CPU temperatures and controllable fan connectors which the BIOS or operating system can use to regulate fan speed. [5] Alternatively computers can use a water cooling system instead of many fans.
12V only System monitoring (P10): This is a 171822-8 AMP or equivalent connector carrying a supply to the PSU fan and sense returns. [31] ATX12V 4-pin power connector (also called the P4 power connector). A second connector that goes to the motherboard (in addition to the 24-pin ATX motherboard connector) to supply dedicated power for the ...
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
Motherboard diagram ru.svg; Motherboard diagram hr.svg; Diagrama de la comunicación entre componentes de un sistema de cómputo.svg; Motherboard diagram fr.svg; Motherboard diagram pl.svg; SVG development
Connectors on this cable would be designated: 1A1W35P1; 1A1W35P2; ASME Y14.44-2008 continues the convention of Plug P and Jack J when assigning references for electrical connectors in assemblies where a J (or jack) is the more fixed and P (or plug) is the less fixed of a connector pair, without regard to the gender of the connector contacts.
Usually, the standoff has a #6-32 UNC male thread on one end which screws into a threaded hole in the case or motherboard backplate and a #6-32 UNC female thread in the other end which accepts a screw to retain the motherboard. Less often, the standoff has a female thread in both ends and a second screw is used to attach it to the case.