Search results
Results from the WOW.Com Content Network
The heating value depends on the source of gas that is used and the process that is used to liquefy the gas. The range of heating value can span ±10 to 15 percent. A typical value of the higher heating value of LNG is approximately 50 MJ/kg or 21,500 BTU/lb. [2] A typical value of the lower heating value of LNG is 45 MJ/kg or 19,350 BTU/lb.
If saturated LNG contacts liquid water (e.g. sea water, which has an average temperature of 15 °C), heat is transferred from the water to the LNG, rapidly vaporizing it. This results in an explosion because the volume occupied by natural gas in its gaseous form is 600 times greater than when its liquefied; this is the phenomenon of rapid phase ...
A non-combustible material [17] is a substance that does not ignite, burn, support combustion, or release flammable vapors when subject to fire or heat, in the form in which it is used and under conditions anticipated. Any solid substance complying with either of two sets of passing criteria listed in Section 8 of ASTM E 136 when the substance ...
There are two kinds of enthalpy of combustion, called high(er) and low(er) heat(ing) value, depending on how much the products are allowed to cool and whether compounds like H 2 O are allowed to condense. The high heat values are conventionally measured with a bomb calorimeter. Low heat values are calculated from high heat value test data.
A 5% displayed LFL reading for methane, for example, would be equivalent to 5% multiplied by 4.4%, or approximately 0.22% methane by volume at 20 degrees C. Control of the explosion hazard is usually achieved by sufficient natural or mechanical ventilation, to limit the concentration of flammable gases or vapors to a maximum level of 25% of ...
Liquefied natural gas is natural gas that has been liquefied for the purpose of storage or transport. Since transportation of natural gas requires a large network of pipeline that crosses through various terrains and oceans, a huge investment and long term planning are required. Before transport, natural gas is liquefied by pressurization.
The reaction is usually endothermic as heat is required to break chemical bonds in the compound undergoing decomposition. If decomposition is sufficiently exothermic, a positive feedback loop is created producing thermal runaway and possibly an explosion or other chemical reaction. Thermal decomposition is a chemical reaction where heat is a ...
In explosives engineering, sensitivity refers to the degree to which an explosive can be initiated by impact, heat, or friction. [1] Current in-use standard methods of mechanical (impact and friction) sensitivity determination differ by the sample preparation (constant mass or volume is usually used; pile or pressed pellet), sample arrangement (confined/unconfined sample etc), instrument type ...