enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Electrical wiring interconnection system - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring...

   An electrical wiring interconnect system (EWIS) is the wiring system and components (such as bundle clamps, wire splices, etc.) for a complex system. The term originated in the aviation industry but was originally designated as Electrical Interconnection Systems (EIS). [1]

3. Line splice - Wikipedia

   en.wikipedia.org/wiki/Line_splice

   Splice site of a copper wire. Cable sleeve (lead sleeve) for connecting paper-insulated wires Insulating sleeves. The splicing of copper wires happens in the following steps: The cores are laid one above the other at the junction. The core insulation is removed. The wires are wrapped two to three times around each other .

4. Rat-tail splice - Wikipedia

   en.wikipedia.org/wiki/Rat-tail_splice

   A rat-tail splice, also known as a twist splice or a pig-tail splice, is a basic electrical splice that can be done with both solid and stranded wire. It is made by taking two or more bare wires and wrapping them together symmetrically around the common axis of both wires. The bare splice can be insulated with electrical tape or by other means.

5. Western Union splice - Wikipedia

   en.wikipedia.org/wiki/Western_union_splice

   Figure parts A–D show steps in forming a "short tie" Western Union splice. Figure parts E and F show two possible "long tie" variations. [2]The Western Union splice or Lineman splice is a method of joining electrical cable, developed in the nineteenth century during the introduction of the telegraph and named for the Western Union telegraph company.

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Crimped connectors are a type of solderless connection, using mechanical friction and uniform deformation to secure a connector to a pre-stripped wire (usually stranded). [1] Crimping is used in splice connectors, crimped multipin plugs and sockets, and crimped coaxial connectors.

7. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.