Ads
related to: fluke cable tester download
Search results
Results from the WOW.Com Content Network
A cable tester is an electronic device used to verify the electrical connections in a signal cable or other wired assembly. Basic cable testers are continuity testers that verify the existence of a conductive path between ends of the cable, and verify the correct wiring of connectors on the cable. More advanced cable testers can measure the ...
Fluke Corporation is an American manufacturer of industrial test, measurement, and diagnostic equipment, including electronic test equipment. It was started in 1948 by John Fluke while he was employed at General Electric .
The delay skew test is used to find the difference in propagation delay between the fastest and slowest set of wire pairs. An ideal skew is between 25 and 50 nanoseconds over a 100-meter cable. The lower this skew the better; less than 25 ns is excellent, but 45 to 50 ns is marginal.
Fluke Model 675 Token Ring / Ethernet LANMeter. A LANMeter was a tool for testing Token Ring and Ethernet networks introduced by Fluke Corporation in 1993. It incorporated hardware testing (cable and network interface card) and active network testing in a handheld, battery operated package.
The conventionally used aid in cable fault testing and location is the cable test van. The van is installed with conventional cable measuring systems for quickly reaching the location of any cable fault. In 20 years that followed, over 2000 fault location vehicles were manufactured, more than half of which were intended for the former USSR.
These traces were produced by a commercial TDR using a step waveform with a 25 ps risetime, a sampling head with a 35 ps risetime, and an 18-inch (0.46 m) SMA cable. [9] The far end of the SMA cable was left open or connected to different adapters. It takes about 3 ns for the pulse to travel down the cable, reflect, and reach the sampling head.
AOL Mail welcomes Verizon customers to our safe and delightful email experience!
The Category 7 cable standard was ratified in 2002, and primarily introduced to support 10 gigabit Ethernet over 100 m of copper cabling. [2] It contains four twisted copper wire pairs, just like the earlier standards, terminated either with GG45 electrical connectors or with TERA connectors rated for transmission frequencies of up to 600 MHz.
Ads
related to: fluke cable tester download