Search results
Results from the WOW.Com Content Network
[note 1] An accumulator enables a hydraulic system to cope with extremes of demand using a less powerful pump, to respond more quickly to a temporary demand, and to smooth out pulsations. It is a type of energy storage device. Compressed gas accumulators, also called hydro-pneumatic accumulators, are by far the most common type.
These accumulators are divided into two compartments by a movable piston, one side filled with hydraulic fluid and the other with nitrogen gas. The nitrogen is held in large tanks directly beneath the actual accumulator. As the hydraulic fluid fills the accumulators, it pushes on the pistons, compressing the nitrogen.
A typical subsea deepwater blowout preventer system includes components such as electrical and hydraulic lines, control pods, hydraulic accumulators, test valve, kill and choke lines and valves, riser joint, hydraulic connectors, and a support frame. Two categories of blowout preventer are most prevalent: ram and annular. BOP stacks frequently ...
The hydraulic station used Otto 'Silent' type gas engines, and had two accumulators, with an 18-inch (460 mm) diameter piston, a stroke of 20 feet (6.1 m) and each loaded with a 93-tonne weight. The gas engines were started by a small hydraulic engine, which used the hydraulic energy stored in the accumulators, and all equipment was supplied by ...
A fluid power system has a pump driven by a prime mover (such as an electric motor or internal combustion engine) that converts mechanical energy into fluid energy, Pressurized fluid is controlled and directed by valves into an actuator device such as a hydraulic cylinder or pneumatic cylinder, to provide linear motion, or a hydraulic motor or pneumatic motor, to provide rotary motion or torque.
The Dock Tower continued to provide water for hydraulic working until 1892 when the erection of the hydraulic accumulator tower on the opposite pier approximately 200 feet (61 m) to the North West of the Dock Tower took over - water in this structure was pressurised by a 300-tonne weight. Present dock and lock machinery are powered by electric ...
The water jet system's cutting head restricts the water flow to generate pressure and direct it onto the workpiece. A holding tank, called a hydraulic accumulator, is used to reduce pressure vibrations at the output end. The more recently developed parallel hydraulic intensifier also uses oscillating pistons to compress water.
Hydraulic accumulators (6 P) ... Delta Works (23 P) F. Hydraulic fluids (11 P) H. Hydraulic engineering (18 C, 161 P) Hydraulic tools (11 P) M. Hydraulic machinery (1 ...