enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Spindle oil - Wikipedia

   en.wikipedia.org/wiki/Spindle_oil

   Spindle oils are a type of low-viscosity mineral oil marketed for use in lubrication of high-speed machine spindles. [1] Spindle oil is free from gumming properties. [2] Since the viscosity is so low that the oil runs off the surface of the spindle during shut-down periods, the spindle oil may be doped with additives that prevent rusting.

3. Shaft (mechanical engineering) - Wikipedia

   en.wikipedia.org/wiki/Shaft_(mechanical_engineering)

   The following stresses are induced in the shafts. Shear stresses due to the transmission of torque (due to torsional load). Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft. Stresses due to combined torsional and bending loads.

4. Fluid bearing - Wikipedia

   en.wikipedia.org/wiki/Fluid_bearing

   Such bearings should be equipped with the shaft position control system, which adjusts the fluid pressure and consumption according to the rotation speed and shaft load. [4] In fluid-dynamic bearings, the bearing rotation sucks the fluid on to the inner surface of the bearing, forming a lubricating wedge under or around the shaft.

5. Drive shaft - Wikipedia

   en.wikipedia.org/wiki/Drive_shaft

   A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a component for transmitting mechanical power, torque, and rotation, usually used to connect other components of a drivetrain that cannot be connected directly because of distance or the need to ...

6. Spindle (tool) - Wikipedia

   en.wikipedia.org/wiki/Spindle_(tool)

   A machine tool may have several spindles, such as the headstock and tailstock spindles on a bench lathe. The main spindle is usually the biggest one. References to "the spindle" without further qualification imply the main spindle. Some machine tools that specialize in high-volume mass production have a group of 4, 6, or even more main spindles.

7. Gear - Wikipedia

   en.wikipedia.org/wiki/Gear

   The two equal but opposite angles add to zero: the angle between shafts is zero—that is, the shafts are parallel. Where the sum or the difference (as described in the equations above) is not zero, the shafts are crossed. For shafts crossed at right angles, the helix angles are of the same hand because they must add to 90 degrees. (This is the ...

8. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

9. Coupling - Wikipedia

   en.wikipedia.org/wiki/Coupling

   A gear coupling is a mechanical device for transmitting torque between two shafts that are not collinear. It consists of a flexible joint fixed to each shaft. The two joints are connected by a third shaft, called the spindle. Each joint consists of a 1:1 gear ratio internal–external gear pair.