enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The collets or tool holders are placed directly into the spindle and the drawbar is tightened into the top of the collet or tool holder from above the spindle. Other tools such as drill chucks, fly cutters, indexable insert cutters, etc. may have an R8 taper shank built into or added to the tool.

3. Magnetic drilling machine - Wikipedia

   en.wikipedia.org/wiki/Magnetic_drilling_machine

   A morse taper 3 arbor equipped magnetic drill machine using taper shank drill bits. The arbor or chuck on a magnetic drill is attached to the motor. It is a type of clamp used to attach the core drills. There are mainly two types of chuck available for the magnetic drill, industrial arbor (manual tightening) and quick change drill chucks.

4. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   A morse taper reamer is used manually to finish morse taper sleeves. These sleeves are a tool used to hold machine cutting tools or holders in the spindles of machines such as a drill or milling machine. The reamer shown is a finishing reamer.

5. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 3 ⁄ 8 in for a 3 ⁄ 8-16 tap), and / is the thread pitch (1 ⁄ 16 inch in the case of a 3 ⁄ 8-16 tap). For a 3 ⁄ 8-16 tap, the above formula would produce 5 ⁄ 16, which is the correct tap drill diameter. The above formula ultimately results in an approximate 75% thread.

6. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   The image shows a long-series drill compared to its diametric equivalents, all are 11 ⁄ 32 inch (8.7313 mm) in diameter. The equivalent Morse taper drill shown in the middle is of the usual length for a taper-shank drill. The lower drill bit is the jobber or parallel shank equivalent.

7. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.