enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Centrifugal pump - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_pump

   Centrifugal pumps with an internal suction stage such as water-jet pumps or side-channel pumps are also classified as self-priming pumps. [10] Self-Priming centrifugal pumps were invented in 1935. One of the first companies to market a self-priming centrifugal pump was American Marsh in 1938. [citation needed]

3. Centrifugal pump selection and characteristics - Wikipedia

   en.wikipedia.org/wiki/Centrifugal_pump_selection...

   While centrifugal pumps impart momentum to the fluid by motion of blades, positive displacement pumps transfer fluid by variation in the size of the pump’s chamber. Centrifugal pumps can be of rotor or propeller types, whereas positive displacement pumps may be gear-based, piston-based, diaphragm-based, etc. As a general rule, centrifugal ...

4. Sewage pumping - Wikipedia

   en.wikipedia.org/wiki/Sewage_pumping

   KOS+ M openwell submersible pump. Small-scale sewage pumping is normally done by a submersible pump.. This became popular in the early 1960s, when a guide rail system was developed to lift the submersible pump out of the pump station for repair, and ended the dirty and sometimes dangerous task of sending people into the sewage or wet pit. [1]

5. Comparison of pumps - Wikipedia

   en.wikipedia.org/wiki/Comparison_of_pumps

   Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...

6. Pressure tank - Wikipedia

   en.wikipedia.org/wiki/Pressure_tank

   The diaphragm or bladder may itself exert a pressure on the water, but it is usually small and will be neglected in the following discussion. Case 1 is an empty tank at the charging pressure P c (gauge). The total volume of the tank is V t. Case 2 is a tank in use, with the air pressure at pressure P (gauge) and a water volume of V. Referring ...

7. Circulator pump - Wikipedia

   en.wikipedia.org/wiki/Circulator_pump

   The traditional hot water recirculation system uses the existing cold water line as return line from the point of use located farthest from the hot water tank back to the hot water tank. The first of two system types has a pump mounted at the hot water heater while a "normally open" thermostatic control valve gets installed at the farthest ...