Search results
Results from the WOW.Com Content Network
A superabsorbent polymer (SAP) (also called slush powder) is a water-absorbing hydrophilic homopolymers or copolymers [1] that can absorb and retain extremely large amounts of a liquid relative to its own mass. [2] Water-absorbing polymers, which are classified as hydrogels when mixed, [3] absorb aqueous solutions through hydrogen bonding with ...
Liquefaction of gases is physical conversion of a gas into a liquid state (condensation). The liquefaction of gases is a complicated process that uses various compressions and expansions to achieve high pressures and very low temperatures, using, for example, turboexpanders .
Another application of polymer solutions includes the manufacture of fibers by wet or dry spinning or plastic films. Disadvantages of solution polymerization are decrease of monomer and initiator concentration leading to reduction of reaction rate, lower volume utilization of reactor, additional cost of the process related to solvent recycling ...
In physics and chemistry, the phase transitions from solid and gas to liquid (melting and condensation, respectively) may be referred to as liquefaction.The melting point (sometimes called liquefaction point) is the temperature and pressure at which a solid becomes a liquid.
Super-absorbent polymers (SAP) similar to sodium polyacrylate were developed in the 1960s by the U.S. Department of Agriculture. [3] Before the development of these substances, the best water absorbing materials were cellulosic or fiber-based like tissue paper, sponge, cotton, or fluff pulp.
The liquid molecules are more attracted to other liquid molecules as compared to the polymer surface. Because the polymer surfaces are solid surfaces, surface tension cannot be measured in a traditional way such as using a Wilhelmy plate. Instead, contact angles can be used to indirectly estimate the surface tension of polymer surfaces. [3]
A small amount of superabsorbent polymer material is taken (0.1g) and it is placed in the beaker. 100 ml of deionized water is poured into the beaker. After 20 min the swollen polymer was separated by using [filter paper] By weighing the polymer, one can find the swollen capacity of the SAP material. [3]
Devolatilization can be carried out when a polymer is in the solid or liquid phase, with the volatile components going into a liquid or gas phase. Examples are: Solid polymer, liquid phase: Extraction of caprolactam from polyamides with water. [4] Solid polymer, gas phase: Removal of ethylene from polyethylene via air or nitrogen in silos. [5]