Search results
Results from the WOW.Com Content Network
Block diagram of a superheterodyne receiver. The RF front end consists of the components on the left colored red. In a radio receiver circuit, the RF front end, short for radio frequency front end, is a generic term for all the circuitry between a receiver's antenna input up to and including the mixer stage. [1]
RFFE may refer to: RF Front-End Working Group (RFFE) of the MIPI Alliance; Escherichia coli (E. coli) rffE strain (rffE), with mutant defective UDP-N ...
Better models also minimize the change in transmission line impedance at the connection in order to reduce signal reflection and power loss. [1] As the frequency increases, transmission line effects become more important, with small impedance variations from connectors causing the signal to reflect rather than pass through.
MIPI (for Mobile Industry Processor Interface) is a non-profit corporation governed by a board of directors.The Officers of MIPI Alliance include the chairman, vice chairman, secretary, and treasurer.
An RF switch or microwave switch is a device to route high frequency signals through transmission paths. RF (radio frequency) and microwave switches are used extensively in microwave test systems for signal routing between instruments and devices under test (DUT).
Company EDA products Achronix: Achronix Tool Suite ACE; Altera (formerly Intel Programmable Solutions Group; [6] Subsidiary of Intel) Intel acquired Altera in 2015. Intel Quartus Prime (formerly Altera Quartus)
A graphic representation of a daisy chain A daisy garland, a chain of daisy flowers A series of devices connected in a daisy chain layout. In electrical and electronic engineering, a daisy chain is a wiring scheme in which multiple devices are wired together in sequence or in a ring, [1] similar to a garland of daisy flowers.
The purpose of CPRI is to allow replacement of a copper or coax cable connection between a radio transceiver (used example for mobile-telephone communication and typically located in a tower) and a base station/baseband unit [3] (typically located at the ground nearby), so the connection can be made to a remote and more convenient location. [4]