Search results
Results from the WOW.Com Content Network
Small lapping plate made of cast iron. A piece of lead may be used as the lap, charged with emery, and used to cut a piece of hardened steel. The small plate shown in the first picture is a hand lapping plate. That particular plate is made of cast iron. In use, a slurry of emery powder would be spread on the plate and the workpiece simply ...
A hand scraper is a single-edged tool used to scrape metal or other materials from a surface. This may be required where a surface needs to be trued, corrected for fit to a mating part, needs to retain oil (usually on a freshly ground surface), or to give a decorative finish. Surface plates were traditionally made by scraping. [1]
Granite surface plate calibration should be performed routinely to maintain proper flatness and ensure measurement accuracy over time. The intervals between calibrations depends on the environment where the surface plate is located. When needed, lapping or resurfacing is provided to bring measurements within grade guidelines.
Paper and metal license plates are so 2021. California will now allow all drivers the option of getting a digital license plate. Proponents say they’re safer and more convenient for drivers.
The California Department of Motor Vehicles has apologized for an “unacceptable and disturbing” personalized truck license plate that the agency said displayed hate speech related to the ...
The California DMV apologized for a license plate appearing to mock the Oct. 7 attacks on Israel. The car owner's son said it was being misinterpreted.
Engineer's blue is prepared by mixing Prussian blue with a non-drying oily material (for example, grease).The coloured oil is rubbed onto a reference surface, and the workpiece is then rubbed against the coloured reference; the transfer (by contact) of the pigment indicates the position of high spots on the workpiece or conversely highlight low points. [1]
Superfinishing, also known as microfinishing [1] and short-stroke honing, is a metalworking process that improves surface finish and workpiece geometry. This is achieved by removing just the thin amorphous surface layer of fragmented or smeared metal left by the last process with an abrasive stone or tape; this layer is usually about 1 μm in magnitude.