Search results
Results from the WOW.Com Content Network
The rotorhead is where the lift force from the rotor blades act. The rotorhead is connected to the main drive shaft via the Jesus nut, and houses several other components such as the swash plate, flight control linkages and fly-bars. [1] The rotor hub is also where the centre of gravity acts on the helicopter. The rotor head of a Sikorsky S-92
Abrasion strips on helicopter rotor blades are made of metal, often titanium or nickel, which are very hard, but less hard than sand. When a helicopter flies low to the ground in desert environments, sand striking the rotor blade can cause erosion. At night, sand hitting the metal abrasion strip causes a visible corona or halo around the rotor ...
Helicopter flight controls are used to achieve and maintain controlled aerodynamic helicopter flight. [1] Changes to the aircraft flight control system transmit mechanically to the rotor, producing aerodynamic effects on the rotor blades that make the helicopter move in a desired way.
In aeronautics, a swashplate is a mechanical device that translates input via the helicopter flight controls into motion of the main rotor blades. Because the main rotor blades are spinning, the swashplate is used to transmit three of the pilot's commands from the non-rotating fuselage to the rotating rotor hub and mainblades.
The drive shafts of helicopter engines are typically not aligned with the rotor shafts, so the transmission must translate the alignment of the drive shaft to match the shafts of the rotors. Many engine drive shafts are aligned horizontally, yet the main rotor shaft ("mast") is usually vertical, and the tail rotor shaft is often perpendicular ...
A Bell UH-1 Iroquois helicopter. A helicopter is a powered rotorcraft with rotors driven by the engine(s) throughout the flight, allowing it to take off and land vertically, hover, and fly forward, backward, or laterally. Helicopters have several different configurations of one or more main rotors.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The Main rotor attach nut, or "Jesus nut", from a Bell 222U, shown in hand for size perspective (left) and installed with locking key (right). Jesus nut is a slang term for the main rotor retaining nut [1] or mast nut, which holds the main rotor to the mast of some helicopters.