Search results
Results from the WOW.Com Content Network
Powder coating is a type of coating that is applied as a free-flowing, dry powder. Unlike conventional liquid paint, which is delivered via an evaporating solvent, powder coating is typically applied electrostatically and then cured under heat or with ultraviolet light. The powder may be a thermoplastic or a thermosetting polymer. It is usually ...
The commonly known brand name of PTFE-based composition is Teflon by Chemours, [4] a spin-off from DuPont, which originally invented the compound in 1938. [4] Polytetrafluoroethylene is a fluorocarbon solid , as it is a high- molecular-weight polymer consisting wholly of carbon and fluorine .
Polytetrafluoroethylene (PTFE), better known by its trade name Teflon, has many desirable properties which make it an attractive material for numerous industries. It has good chemical resistance, a low dielectric constant, low dielectric loss, and a low coefficient of friction, making it ideal for reactor linings, circuit boards, and kitchen utensils, to name a few applications.
The high kinetic energy of the hot powder particles on impact with the substrate results in a buildup of a very dense and strong coating. The coating adheres through a mechanical bond resulting from the deformation of the base substrate wrapping around the sprayed particles after the high speed impact.
The inventors, having also noted that the tips of walking canes were frequently covered with the relatively soft and malleable Teflon to help them grip surfaces, found that the addition of Teflon helped to prevent bullet deflections from vehicle doors and windshields, further improving penetration against those surfaces.
Ethylene tetrafluoroethylene (ETFE) is a fluorine-based plastic.It was designed to have high corrosion resistance and strength over a wide temperature range. ETFE is a polymer and its source-based name is poly (ethene-co-tetrafluoroethene).
Cold spraying was developed by Russian scientists in the 1990s. While experimenting with the particle erosion of the target, which was exposed to a two-phase high-velocity flow of fine powder in a wind tunnel, scientists observed accidental rapid formation of coatings. This coating technique was commercialized in the 1990s. [1]
Nevertheless the burn rate of MTV, as is the case with many metallized pyrotechnic compositions is strongly dependent on the specific surface area of the metal fuel, that are particle morphology and dimensions. Generally magnesium powder having a high specific surface area will exhibit a higher burn rate than those having a smaller specific area.