Search results
Results from the WOW.Com Content Network
The Sensotronic Brake Control (SBC) system operates using a hydraulic high-pressure reservoir to supply brake fluid. A piston pump, driven by an electric motor, generates controlled brake fluid pressure ranging between 140 bars (2,000 psi) and 160 bars (2,300 psi) in the gas diaphragm reservoir.
The sensor has an input port to measure the hydraulic braking pressure and an electrical connector output for a wire connection for feeding the warning light. Some brake failures do not trip the sensor into a fault mode. A brake fluid pressure sensor is used in anti-lock braking system (ABS). ABS fault lights come on with unexpected wheel lock ...
A bad crank position sensor can worsen the way the engine idles, or the acceleration behaviour. If the engine is revved up with a bad or faulty sensor, it may cause misfiring, motor vibration or backfires. Acceleration might be hesitant, and abnormal shaking during engine idle might occur. In the worst case, the car may not start.
An engine operating at wide open throttle (WOT) on top of a very high mountain has a manifold pressure of about 50 kPa (essentially equal to the barometer at that high altitude). Condition 2: The same engine at sea level will achieve that same 50 kPa (7.25 psi, 14.7 inHG) of manifold pressure at less than (before reaching) WOT due to the higher ...
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
Still, 81% of respondents rated their health insurance as “excellent” or “good,” the same survey found. More than 200 readers have written to CNN since the shooting about their experiences ...
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...
Mangione was found with a gun similar to the one used in the shooting and had a fake ID with the same name the suspected gunman used at a New York City hostel, police said.