Search results
Results from the WOW.Com Content Network
Each bit of the RC-5 code word contains 32 carrier pulses, and an equal duration of silence, so the bit time is 64×27.778 μs = 1.778 ms, and the 14 symbols (bits) of a complete RC-5 code word take 24.889 ms to transmit. The code word is repeated every 113.778 ms (4096 ÷ 36 kHz) as long as a key remains pressed.
LIRC (Linux Infrared remote control) is an open source package that allows users to receive and send infrared signals with a Linux-based computer system. There is a Microsoft Windows equivalent of LIRC called WinLIRC. With LIRC and an IR receiver the user can control their computer with almost any infrared remote control (e.g. a TV remote control).
Infrared (IR): previously included in most mobile devices; Gen2IR (second generation infrared) Visible light communication [10] [54] (VLC), as LiFi: can use existing lighting systems; Ultrasound: [18] waves move very slowly, which results in much higher accuracy; MALLY by Geniusmatcher is a hardware-free solution in any indoor location.
Wi-Charge claims to deliver power using focused beams of invisible infrared light. The system consists of a transmitter and a receiver. Transmitter connects to a standard power outlet and converts electricity into infrared laser beam. Receivers use a miniature photo-voltaic cell to convert transmitted light into electrical power. Receivers can ...
The beam is modulated, i.e. switched on and off, according to a code which the receiver interprets. Usually very near-IR is used (below 800 nm) for practical reasons. This wavelength is efficiently detected by inexpensive silicon photodiodes, which the receiver uses to convert the detected radiation to an electric current.
IR blaster with standard 3.5 mm plug IR blaster attached to a cable TV tuner. An infrared blaster (IR blaster) is a device that relays commands from a remote control to one or more devices that require infra-red remote control. For instance, it may also allow radio-frequency-based (RF) remotes (including those using Bluetooth) to control infra ...
A passive infrared sensor (PIR sensor) is an electronic sensor that measures infrared (IR) light radiating from objects in its field of view. They are most often used in PIR-based motion detectors . PIR sensors are commonly used in security alarms and automatic lighting applications.
BBFuino come with the ATmega328 controller, loaded with Optiboot (Arduino UNO's bootloader), compatible with Arduino IDE and sample code, design to fit breadboard for prototyping and learning, lower down the cost by taking out the USB to UART IC, so the board has the basic component to operate. BlockDuino [161] ATmega8 ATmega328 Blockduino