enow.com Web Search

  1. Ads

    related to: led 120v circuit generator with remote

Search results

  1. Results from the WOW.Com Content Network
  2. LED circuit - Wikipedia

    en.wikipedia.org/wiki/LED_circuit

    In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED. The voltage drop across a lit LED is approximately constant over a wide range of operating

  3. Light-emitting diode - Wikipedia

    en.wikipedia.org/wiki/Light-emitting_diode

    Simple LED circuit with resistor for current limiting. The current in an LED or other diodes rises exponentially with the applied voltage (see Shockley diode equation), so a small change in voltage can cause a large change in current. Current through the LED must be regulated by an external circuit such as a constant current source to prevent ...

  4. Electrical ballast - Wikipedia

    en.wikipedia.org/wiki/Electrical_ballast

    An electronic ballast with an integrated battery is designed to provide emergency egress lighting in the event of a power failure (typically less than 2 hours). These can be used as an alternative to egress lighting powered by a back-up electrical generator.

  5. Opto-isolator - Wikipedia

    en.wikipedia.org/wiki/Opto-isolator

    Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]

  6. Current-mode logic - Wikipedia

    en.wikipedia.org/wiki/Current-mode_logic

    Current mode logic (CML), or source-coupled logic (SCL), is a digital design style used both for logic gates and for board-level digital signaling of digital data.. The basic principle of CML is that current from a constant current generator is steered between two alternate paths depending on whether a logic zero or logic one is being represented.

  7. Stand-alone power system - Wikipedia

    en.wikipedia.org/wiki/Stand-alone_power_system

    A stand-alone power system (SAPS or SPS), also known as remote area power supply (RAPS), is an off-the-grid electricity system for locations that are not fitted with an electricity distribution system. Typical SAPS include one or more methods of electricity generation, energy storage, and regulation.

  1. Ads

    related to: led 120v circuit generator with remote