enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Oil pressure - Wikipedia

    en.wikipedia.org/wiki/Oil_pressure

    Murphy oil pressure gauges with switches that activate on low pressure. Oil pressure is an important factor in the longevity of most internal combustion engines. [1] With a forced lubrication system (invented by Frederick Lanchester), oil is picked up by a positive displacement oil pump and forced through oil galleries (passageways) into bearings, such as the main bearings, big end bearings ...

  3. Oil pump (internal combustion engine) - Wikipedia

    en.wikipedia.org/wiki/Oil_pump_(internal...

    Indications of low oil pressure may be that the warning light is on, a low pressure reading on the gauge, or clattering/clinking noises from the engine. Low oil pressure is a problem that must be addressed immediately to prevent serious damage. The leading cause of low oil pressure in an engine is wear on the engine's vital parts.

  4. Tell-tale (automotive) - Wikipedia

    en.wikipedia.org/wiki/Tell-tale_(automotive)

    The oil pressure idiot light lights when engine oil pressure drops below a predetermined level. The light normally appears when the vehicle ignition is turned on, but the engine is not running, as it detects no oil pressure due to the oil pump not operating (the oil pump is powered off the crankshaft, so only operates when the engine is running ...

  5. MAP sensor - Wikipedia

    en.wikipedia.org/wiki/MAP_sensor

    MAP sensors measure absolute pressure. Boost sensors or gauges measure the amount of pressure above a set absolute pressure. That set absolute pressure is usually 100 kPa. This is commonly referred to as gauge pressure. Boost pressure is relative to absolute pressure - as one increases or decreases, so does the other.

  6. Ford Power Stroke engine - Wikipedia

    en.wikipedia.org/wiki/Ford_Power_Stroke_engine

    High Pressure Oil System – With the use of split-shot HEUI fuel injectors, high-pressure oil is required to pressurize the fuel injectors. The main high-pressure oil (HPO) system components are the high-pressure oil pump (HPOP), HPO manifolds, stand pipes, and branch tube. The HPOP is located in the engine valley at the rear of the engine block.

  7. Pressure measurement - Wikipedia

    en.wikipedia.org/wiki/Pressure_measurement

    Instruments used to measure and display pressure mechanically are called pressure gauges, vacuum gauges or compound gauges (vacuum & pressure). The widely used Bourdon gauge is a mechanical device, which both measures and indicates and is probably the best known type of gauge.

  8. Pressure switch - Wikipedia

    en.wikipedia.org/wiki/Pressure_switch

    Murphy oil pressure gauges with switches that activate on low pressure. A pressure switch is a form of switch that operates an electrical contact when a certain set fluid pressure has been reached on its input. The switch may be designed to make contact either on pressure rise or on pressure fall.

  9. Pigging - Wikipedia

    en.wikipedia.org/wiki/Pigging

    Pigs are used in lube oil or paint blending to clean the pipes to avoid cross-contamination, and to empty the pipes into the product tanks (or sometimes to send a component back to its tank). Usually pigging is done at the beginning and at the end of each batch, but sometimes it is done in the midst of a batch, such as when producing a premix ...