Search results
Results from the WOW.Com Content Network
Bilge compartment in a steel hulled ship (looking down) Bilge compartment and pump. The bilge / b ɪ l dʒ / of a ship or boat is the part of the hull that would rest on the ground if the vessel were unsupported by water. The "turn of the bilge" is the transition from the bottom of a hull to the sides of a hull.
Below: a lower deck of the ship. [1] Belowdecks: inside or into a ship, or down to a lower deck. [13] Bilge: the underwater part of a ship between the flat of the bottom and the vertical topsides [14] Bottom: the lowest part of the ship's hull. Bow: front of a ship (opposite of "stern") [1]
The ship that would be known as Queen Anne's Revenge was a 200-ton vessel believed to have been built in 1710. She was handed over to René Duguay-Trouin and employed in his service for some time before being converted into a slave ship, then operated by the leading slave trader René Montaudin of Nantes, until sold in 1713 in Peru or Chile.
The keel is often the first part of a ship's hull to be constructed, and laying the keel, or placing the keel in the cradle where the ship will be built, may mark the start time of its construction. Large, modern ships are now often built in a series of pre-fabricated, complete hull sections rather than being built around a single keel, so the ...
It was an official, though rare, punishment in the Dutch navy, [15] as shown in the painting The keelhauling of the ship's surgeon of Admiral Jan van Nes. This shows a large crowd gathered to watch the event, as though it was a "show" punishment intended to frighten other potential offenders, as was flogging round the fleet.
A hull is the watertight body of a ship, boat, submarine, or flying boat. The hull may open at the top (such as a dinghy ), or it may be fully or partially covered with a deck. Atop the deck may be a deckhouse and other superstructures , such as a funnel, derrick, or mast .
Graphical representation of the dimensions used to describe a ship. Dimension "b" is the beam at waterline.. The beam of a ship is its width at its widest point. The maximum beam (B MAX) is the distance between planes passing through the outer sides of the ship, beam of the hull (B H) only includes permanently fixed parts of the hull, and beam at waterline (B WL) is the maximum width where the ...
Sail components include the features that define a sail's shape and function, plus its constituent parts from which it is manufactured. A sail may be classified in a variety of ways, including by its orientation to the vessel (e.g. fore-and-aft) and its shape, (e.g. (a)symmetrical, triangular, quadrilateral, etc.).