enow.com Web Search

  1. Ads

    related to: ethernet usb female adapter port protection 10 in x

Search results

  1. Results from the WOW.Com Content Network
  2. Ethernet over USB - Wikipedia

    en.wikipedia.org/wiki/Ethernet_over_USB

    Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.

  3. Attachment Unit Interface - Wikipedia

    en.wikipedia.org/wiki/Attachment_Unit_Interface

    An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.

  4. USB hardware - Wikipedia

    en.wikipedia.org/wiki/USB_hardware

    To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...

  5. USB communications device class - Wikipedia

    en.wikipedia.org/wiki/USB_communications_device...

    USB communications device class (or USB CDC) is a composite Universal Serial Bus device class. The communications device class is used for computer networking devices akin to a network card , providing an interface for transmitting Ethernet or ATM frames onto some physical media.

  6. Medium-dependent interface - Wikipedia

    en.wikipedia.org/wiki/Medium-dependent_interface

    These are referred to as MDI and MDI-X (medium-dependent interface crossover). When connecting an MDI port to an MDI-X port, a straight-through cable is used, while to connect two MDI ports or two MDI-X ports, a crossover cable must be used. Conventionally, MDI is used on end devices and routers while MDI-X is used on hubs and switches.

  7. USB - Wikipedia

    en.wikipedia.org/wiki/USB

    The throughput of each USB port is determined by the slower speed of either the USB port or the USB device connected to the port. High-speed USB 2.0 hubs contain devices called transaction translators that convert between high-speed USB 2.0 buses and full and low speed buses. There may be one translator per hub or per port.

  1. Ads

    related to: ethernet usb female adapter port protection 10 in x