enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Brake bleeding - Wikipedia

   en.wikipedia.org/wiki/Brake_bleeding

   A brake bleed screw is normally mounted at the highest point on each cylinder or caliper. There are five main methods of bleeding: [1] The pump and hold method, the brake pedal is pressed while one bleed screw at a time is opened, allowing air to escape. The bleed screw must be closed before releasing the pedal, or a one-way valve must be fitted.

3. International K and KB series - Wikipedia

   en.wikipedia.org/wiki/International_K_and_KB_series

   The International K and KB series are trucks that were produced by International Harvester, the first being the K introduced in mid 1940.In total there were 42 models, 142 different wheelbase lengths and load ratings ranging from 1/2 ton to 90,000 lbs. [1] They are best known for their durability, prewar design in a postwar era, and low price.

4. Bleed screw - Wikipedia

   en.wikipedia.org/wiki/Bleed_screw

   Bleed screw key Bleed screw key in use at a domestic radiator. On a home radiator unit, the bleed screw can be opened, usually by means of a key, to allow unwanted air to escape from the unit. Bleed screws are also found on some pump types fulfilling a similar purpose. They are most often located at the top of the radiator on the side of the ...

5. Brake balance - Wikipedia

   en.wikipedia.org/wiki/Brake_balance

   The brake balance or brake bias of a vehicle is the distribution of brake force at the front and rear tires, and may be given as the percentage distributed to the front brakes (e.g. 52%) [1] or as the ratio of front and rear percentages (e.g. 52/48). [2]

6. Brake fluid - Wikipedia

   en.wikipedia.org/wiki/Brake_fluid

   DOT 5.1 fluids are specified with low viscosity over a wide range of temperatures, although not all cars fitted with ABS or ESP specify DOT 5.1 brake fluid. [14] For a faster reaction of the ABS and ESP systems, DOT 4 and DOT 5.1 brake fluids exist with low viscosity meeting the maximum 750 mm 2 /s viscosity at −40 °C (−40 °F) requirement ...

7. Hydraulic brake - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_brake

   The driver's brake pedal simply controls a valve to bleed pressure into the brake units at the wheels, rather than actually creating the pressure in a master cylinder by depressing a piston. This form of brake is analogous to an air brake system but with hydraulic fluid as the working medium rather than air.