enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   All DWV systems require various sized fittings and pipes which are measured by their internal diameter of both the pipes and the fittings which, and in most cases are Schedule 40 PVC wye's, tee's, elbows ranging from 90 degrees to 22.5 degrees for both inside diameter fitment (street) as well as outer diameter fitment (hub), repair and slip ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Flexible rubber sleeves are used to connect this cast-iron and copper DWV installation. Cast iron DWV pipe and fittings are still used in premium construction because they muffle the sound of wastewater rushing through them, [22]: 149 but today they are rarely joined with traditional lead joints.

4. Electrical conduit - Wikipedia

   en.wikipedia.org/wiki/Electrical_conduit

   Fittings for non-threaded conduits are either secured with set screws or with a compression nut that encircles the conduit. Fittings for general purpose use with metal conduits may be made of die-cast zinc, but where stronger fittings are needed, they are made of copper-free aluminum or cast iron. Couplings connect two pieces of conduit together.

5. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

6. Street elbow - Wikipedia

   en.wikipedia.org/wiki/Street_elbow

   Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

7. Pattern (casting) - Wikipedia

   en.wikipedia.org/wiki/Pattern_(casting)

   For the production of gray iron, ductile iron and steel castings, sand casting remains the most widely used process. For aluminum castings, sand casting represents about 12% of the total tonnage by weight (surpassed only by die casting at 57%, and semi-permanent and permanent mold at 19%; based on 2006 shipments). The exact process and pattern ...

8. MOST-WATCHED PRIMETIME TELECASTS OF 2024 (TOTAL VIEWERS) - AOL

   www.aol.com/100-most-watched-telecasts-2024...

   The 100 Most-Watched Telecasts of 2024: NFL, Paris Olympics, Presidential Debate, Lots of ‘Tracker’ and the ‘Young Sheldon’ Finale

9. Sprue (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Sprue_(manufacturing)

   The runner is a smaller channel from the sprue to the individual part. An analogy may be found in a water system that employs a water main (sprue) and smaller pipes (runners) to individual houses. The gate is the location at which the molten plastic enters the mold cavity and is often evidenced by a small nub or projection (the "gate mark") on ...