Search results
Results from the WOW.Com Content Network
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
The precision is 1 (1 decimal place), and units are abbreviated and linked. {{convert ... hand}} → 14.2 to 16.1 hands (58 to 65 inches; 147 to 165 cm) Mach (unit of ...
So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths). (Decimal places for .25, .5, and .75 are shown to thousandths [.250, .500, .750], which is how machinists usually think ...
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
1 inch = 8 soot for 8 division tape/scale 1 inch = 16 division that means measurement is more accurate(1,1.5,2,2.5,3...and so on until 8) 1 inch = 32 division that means 1 soot is divided into 4 parts for more accurate readings. The above was added to the article. I found it difficult to understand and it had no references.
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...
A handy chart of decimal-fraction equivalents, 0 to 1 by 64ths. Prints nicely as 11x17 in landscape orientation. Useful for machinists who work with inch-based measurements. Date: 24 October 2007: Source: Own work: Author: Three-quarter-ten
10.16 cm = 1.016 dm – 1 hand used in measuring height of horses (4 inches) 12 cm = 1.2 dm – diameter of a compact disc (CD) (= 120 mm) 15 cm = 1.5 dm – length of a Bic pen with cap on; 22 cm = 2.2 dm – diameter of a typical association football (soccer ball) 30 cm = 3 dm – typical school-use ruler length (= 300 mm)