enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]

3. Nibbler - Wikipedia

   en.wikipedia.org/wiki/Nibbler

   Manual nibbler, punch-and-die type. A nibbler, or nibblers, [1] is a tool for cutting sheet metal with minimal distortion. They may be used for nibbling.One type operates much like a punch and die, with a blade that moves in a linear fashion against a fixed die, removing small bits of metal and leaving a kerf approximately 6 mm (0.24 in) wide.

4. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.

5. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   The origins of the hole punch date back to Germany; Friedrich Soennecken filed his patent on 14 November 1886, for his Papierlocher für Sammelmappen, a multiple-hole punch and office supply product. [1] [2] A Google Doodle was used on 14 November 2017 to celebrate the 131st anniversary of the hole punch. [3] The first record for a single-hole ...

6. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   Punching is a forming process that uses a punch press to force a tool, called a punch, through the workpiece to create a hole via shearing. Punching is applicable to a wide variety of materials that come in sheet form, including sheet metal, paper, vulcanized fibre and some forms of plastic sheet. The punch often passes through the work into a ...

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.