enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Oil pump (internal combustion engine) - Wikipedia

   en.wikipedia.org/wiki/Oil_pump_(internal...

   [c] These are supplementary pumps and do not replace the main, mechanical, oil pump. Electric pump as a main engine pump again will require big electric motors and it may be simply cheaper to drive directly from the engine. For e.g. BMW S65 engine's oil pump delivers ca. 45 LPM (Litres Per Minute) of oil at 5.5 bar pressure. [5]

3. Core plug - Wikipedia

   en.wikipedia.org/wiki/Core_plug

   Core plugs are usually thin metal cups press fitted into the casting holes, but may be made of rubber or other materials. The most common metal plugs used in automotive engines are made from plated mild steels, stainless steels, brass or bronze. In some high-performance engines the core plugs are large diameter cast metal threaded pipe plugs. [3]

4. Crankcase ventilation system - Wikipedia

   en.wikipedia.org/wiki/Crankcase_ventilation_system

   Dry sump engines in some drag racing cars use scavenging pumps to extract oil and gases from the crankcase. [18] A separator removes the oil, then the gases are fed into the exhaust system via a venturi tube. [citation needed]. This system maintains a small amount of vacuum in the crankcase and minimises the amount of oil in the engine that ...

5. Dry sump - Wikipedia

   en.wikipedia.org/wiki/Dry_sump

   The dry-sump system uses two or more oil pumps and a separate oil reservoir, as opposed to a conventional wet-sump system, which uses only the main sump (U.S.: oil pan) below the engine and a single pump. A dry-sump engine requires a pressure relief valve to regulate negative pressure inside the engine, so internal seals are not inverted.

6. Plugs vs. Pump: How Much It Actually Costs to Charge an ...

   www.aol.com/plugs-vs-pump-much-actually...

   We break down how much it costs to charge an electric vehicle at home and at public charging stations. Plus, whether installing a level 2 charger is worth it.

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A plug is a short barbed fitting with a blank end that can only be used with PEX piping to end the continuation of a water line that is no longer in use due to tying in elsewhere within the system or to seal the end of a water line which may be used for future use in the case of additional facilities. All plugs are sealed watertight with a PEX ...