Search results
Results from the WOW.Com Content Network
A deep foundation is a type of foundation that transfers building loads to the earth farther down from the surface than a shallow foundation does to a subsurface layer or a range of depths. A pile or piling is a vertical structural element of a deep foundation, driven or drilled deep into the ground at the building site .
Push-the-bit tools use pads on the outside of the tool which press against the well bore thereby causing the bit to press on the opposite side causing a direction change. Point-the-bit technologies cause the direction of the bit to change relative to the rest of the tool by bending the main shaft running through it.
Thermal Integrity Profiling (TIP) is a non-destructive testing method used to evaluate the integrity of concrete foundations. It is standardized by ASTM D7949 - Standard Test Methods for Thermal Integrity Profiling of Concrete Deep Foundations. The testing method was first developed in the mid 1990s at the University of South Florida.
A continuous flight auger drill is used to excavate a hole and concrete is injected through a hollow shaft under pressure as the auger is extracted. Reinforcement is then inserted after the auger is removed. [1] This creates a continuous pile without ever leaving an open hole.
Schematic cross section of a pressurized caisson. In geotechnical engineering, a caisson (/ ˈ k eɪ s ən,-s ɒ n /; borrowed from French caisson 'box', from Italian cassone 'large box', an augmentative of cassa) is a watertight retaining structure [1] used, for example, to work on the foundations of a bridge pier, for the construction of a concrete dam, [2] or for the repair of ships.
The development of the recent years with frequent new releases is focused on improving Sesam as a tool for all phases of offshore and maritime structures from design, through transportation, installation, operation and modification to life extension, requalification and finally decommissioning.
A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.
In civil engineering a shaft is an underground vertical or inclined passageway. Shafts are often entered through a manhole and closed by a manhole cover. They are constructed for a number of reasons including: For the construction of a tunnel; For ventilation of a tunnel or underground structure, aka ventilation shaft