Ad
related to: febco ball valve parts drawing system for kids
Search results
Results from the WOW.Com Content Network
A ball valve is a flow control device which uses a hollow, perforated, and pivoting ball to control fluid flowing through it. It is open when the hole through the middle of the ball is in line with the flow inlet, and closed when it is pivoted 90 degrees by the valve handle, blocking the flow. [1] The handle lies flat in alignment with the flow ...
Fuel intake to the engine is controlled by a simple needle valve and venturi system. Fuel/air mixture intake to the crankcase is controlled via a reed valve or rotary valve depending on the engine design. In a reed valve engine, the valve is drawn open by suction as the piston moves upward on the compression stroke. As the piston moves down on ...
Four-way valve. The four-way valve or four-way cock is a fluid control valve whose body has four ports equally spaced round the valve chamber and the plug has two passages to connect adjacent ports. The plug may be cylindrical or tapered, or a ball. It has two flow positions, and usually a central position where all ports are closed. It can be ...
The balls swing out as speed increases, which closes the valve, until a balance is achieved between demand and the proportional gain of the linkage and valve. A centrifugal governor is a specific type of governor with a feedback system that controls the speed of an engine by regulating the flow of fuel or working fluid , so as to maintain a ...
The most common final control element in the process control industries is the control valve. The control valve manipulates a flowing fluid, such as gas, steam, water, or chemical compounds, to compensate for the load disturbance and keep the regulated process variable as close as possible to the desired set point. [1]
Appearance. Engineering drawing abbreviations and symbols are used to communicate and detail the characteristics of an engineering drawing. This list includes abbreviations common to the vocabulary of people who work with engineering drawings in the manufacture and inspection of parts and assemblies. Technical standards exist to provide ...
A petcock is a small shut-off valve used to control the flow of liquid or gas. Historically, petcocks were threaded valves controlled by a butterfly handle; [citation needed] modern petcocks are typically ball valves. Compared to the progressive control of a gate valve a ball valve style petcock's is coarse, confining their use principally to ...
Contains either high-pressure compressed air or air at lower than atmospheric pressure (vacuum), depending on whether the locomotive has an air brake or vacuum brake system. [6]: 483–486 [3]: 1. Water compartment. Tank for water to be used by the boiler to produce steam. [3]: 79. Coal bunker.
Ad
related to: febco ball valve parts drawing system for kids