enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   A USB cable, by definition, has a plug on each end—one A (or C) and one B (or C)—and the corresponding receptacle is usually on a computer or electronic device. The mini and micro formats may connect to an AB receptacle, which accepts either an A or a B plug, that plug determining the behavior of the receptacle.

3. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   Historically this was made clear by the fact that hosts had only Type-A ports and peripheral devices had only Type-B, and every (valid) cable had one Type-A plug and one Type-B plug. USB-C (Type-C) is a single connector that replaces all Type-A and Type-B connectors (legacy connectors), so when both sides are modern equipment with USB-C ports ...

4. Arduino Nano - Wikipedia

   en.wikipedia.org/wiki/Arduino_Nano

   The Arduino Nano is an open-source breadboard -friendly microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2008. It offers the same connectivity and specs of the Arduino Uno board in a smaller form factor. [1]

5. USB-C - Wikipedia

   en.wikipedia.org/wiki/USB-C

   USB-C, or USB Type-C, is a 24-pin connector (not a protocol) that supersedes previous USB connectors and can carry audio, video, and other data, to connect to monitors or external drives. It can also provide and receive power, to power, e.g., a laptop or a mobile phone. It is used not only by USB technology, but also by other protocols ...

6. USB 3.0 - Wikipedia

   en.wikipedia.org/wiki/USB_3.0

   A deprecated [2] SuperSpeed USB 5 Gbit/s packaging logo. Universal Serial Bus 3.0 (USB 3.0), marketed as SuperSpeed USB, is the third major version of the Universal Serial Bus (USB) standard for interfacing computers and electronic devices. It was released in November 2008.

7. USB On-The-Go - Wikipedia

   en.wikipedia.org/wiki/USB_On-The-Go

   The standard OTG cable has a mini-A plug on one end and a mini-B plug on the other end (it can not have two plugs of the same type). The device with a mini-A plug inserted becomes an OTG A-device, and the device with a mini-B plug inserted becomes a B-device (see above). The type of plug inserted is detected by the state of the ID pin (the mini ...