Ads
related to: cat 5 crossover cable pinouts for sale
Search results
Results from the WOW.Com Content Network
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers) or two switches to each other. By contrast, straight through patch cables are used to connect devices of ...
A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...
Category 5 cable (Cat 5) is a twisted pair cable for computer networks. Since 2001, the variant commonly in use is the Category 5e specification (Cat 5e). The cable standard provides performance of up to 100 MHz and is suitable for most varieties of Ethernet over twisted pair up to 2.5GBASE-T [1][2][3][4] but more commonly runs at 1000BASE-T ...
An 8P8C modular plug. This is the common crimp-type plug, of the same kind pictured above crimped onto a cable (with molded sleeve). A modular connector is a type of electrical connector for cords and cables of electronic devices and appliances, such as in computer networking, telecommunication equipment, and audio headsets. Modular connectors ...
Crossover cable. A null modem cable. A crossover cable connects two devices of the same type, for example DTE -DTE or DCE -DCE, usually connected asymmetrically (DTE-DCE), by a modified cable called a crosslink. [1] Such a distinction between devices was introduced by IBM. The crossing of wires in a cable or in a connector adaptor allows:
25-pair telco cable pinout. A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.
Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...
Common for current LANs. Superseded by Cat 5e, but most Cat 5 cables meet Cat 5e standards. [18] Limited to 100 m between equipment. Cat 5e: UTP, [18] F/UTP, U/FTP [19] 100 MHz [18] 1000BASE-T, 2.5GBASE-T [18] Enhanced Cat 5. Common for current LANs. Same construction as Cat 5, but with better testing standards. [18] Limited to 100m between ...
Ads
related to: cat 5 crossover cable pinouts for sale