Search results
Results from the WOW.Com Content Network
In circuit theory, flux linkage is a property of a two-terminal element. It is an extension rather than an equivalent of magnetic flux and is defined as a time integral [citation needed] where is the voltage across the device, or the potential difference between the two terminals. This definition can also be written in differential form as a rate.
Magnetic reluctance in a magnetic circuit is analogous to electrical resistance in an electrical circuit in that resistance is a measure of the opposition to the electric current. The definition of magnetic reluctance is analogous to Ohm's law in this respect. However, magnetic flux passing through a reluctance does not give rise to dissipation ...
Faraday's law states that the emf is also given by the rate of change of the magnetic flux: where is the electromotive force (emf) and ΦB is the magnetic flux. The direction of the electromotive force is given by Lenz's law. The laws of induction of electric currents in mathematical form was established by Franz Ernst Neumann in 1845.
The class of electronic devices handling power greater than a watt. power engineering. That part of electrical engineering that deals with the generation, distribution and consumption of electrical power. power-factor correction. Apparatus intended to bring the power factor of some load closer to 1. power factor.
Synchronous motor. Miniature synchronous motor used in analog clocks. The rotor is made of permanent magnet. Small synchronous motor with integral stepdown gear from a microwave oven. A synchronous electric motor is an AC electric motor in which, at steady state, [1] the rotation of the shaft is synchronized with the frequency of the supply ...
Lenz's law states that: The current induced in a circuit due to a change in a magnetic field is directed to oppose the change in flux and to exert a mechanical force which opposes the motion. Lenz's law is contained in the rigorous treatment of Faraday's law of induction (the magnitude of EMF induced in a coil is proportional to the rate of ...
Magnetic flux. In physics, specifically electromagnetism, the magnetic flux through a surface is the surface integral of the normal component of the magnetic field B over that surface. It is usually denoted Φ or ΦB. The SI unit of magnetic flux is the weber (Wb; in derived units, volt–seconds), and the CGS unit is the maxwell [1].
Dielectric reluctance. Dielectric reluctance is a scalar measurement of a passive dielectric circuit (or element within that circuit) dependent on voltage and electric induction flux, and this is determined by deriving the ratio of their amplitudes. The units of dielectric reluctance are F −1 (inverse farads —see daraf) [Ref. 1-3].