Search results
Results from the WOW.Com Content Network
There will be 5 MHz×10 ms = 50,000 samples in the digital signal, and therefore 25,001 frequency components ranging from 0 Hz to 2.5 MHz in steps of 100 Hz (note that the 0 Hz component is real because it is the average of a real-valued signal and the 2.5 MHz component is real as well because it is the critical frequency).
The navigational signals transmitted by GPS satellites encode a variety of information including satellite positions, the state of the internal clocks, and the health of the network. These signals are transmitted on two separate carrier frequencies that are common to all satellites in the network.
General Packet Radio Service (GPRS), also called 2.5G, is a mobile data standard on the 2G cellular communication network's global system for mobile communications (GSM). [1] Networks and mobile devices with GPRS started to roll out around the year 2001; [2] it offered, for the first time on GSM networks, seamless data transmission using packet ...
Binary offset carrier modulation [1] [2] (BOC modulation) was developed by John Betz in order to allow interoperability of satellite navigation systems. It is currently used in the US GPS system, Indian IRNSS system and in Galileo [3] and is a square sub-carrier modulation, where a signal is multiplied by a rectangular sub-carrier of frequency equal to or greater than the chip rate.
The Galileo Navigation System, the GLONASS System, and the BeiDou systems use the L band similar to GPS, although the frequency ranges are named differently. Modern receivers, such as those found in smartphones , are able to take advantage of multiple systems (usually only around the oldest L1 band) at the same time.
A Gold code, also known as Gold sequence, is a type of binary sequence, used in telecommunications [1] and satellite navigation (). [2] Gold codes are named after Robert Gold.
Ideally, clocks in a telecommunications network are synchronous, controlled to run at identical rates, or at the same mean rate with a fixed relative phase displacement, within a specified limited range. However, they may be mesochronous in practice. In common usage, mesochronous networks are often described as synchronous.
In telecommunications, the carrier-to-noise ratio, often written CNR or C/N, is the signal-to-noise ratio (SNR) of a modulated signal. The term is used to distinguish the CNR of the radio frequency passband signal from the SNR of an analog base band message signal after demodulation. For example, with FM radio, the strength of the 100 MHz ...