Search results
Results from the WOW.Com Content Network
A dog-leg staircase A quarter-landing, on a dog-leg staircase, is made into an architectural feature, by the use of arches, vaulting and stained glass. A dog-leg is a configuration of stairs between two floors of a building, often a domestic building, in which a flight of stairs ascends to a quarter-landing before turning at a right angle and continuing upwards. [1]
A 10-panel truss requires counter-braces in every panel but the end panels, and these should be at least one-half as strong as the braces. A Howe truss bridge can be strengthened to achieve a live load to dead load ratio of 2-to-1. If this ratio is 2-to-1 or greater, then a six-panel truss must have counter-braces and these must at least one ...
Building a palisade wall for the fort at Jamestown, Virginia The Golden Plow Tavern in York, PA, is a very unusual American building. It is built with corner post construction on the ground floor, half-timbered style of timber framing on the upper floor and has a less common style of wood roof shingles than typical in America.
In half-timbered construction, timbers that were riven (split) in half provided the complete skeletal framing of the building. Europe is full of timber-framed structures dating back hundreds of years, including manors, castles, homes, and inns, whose architecture and techniques of construction have evolved over the centuries.
A stair flight is a run of stairs or steps between landings. A stairwell is a compartment extending vertically through a building in which stairs are placed. A stair hall is the stairs, landings, hallways, or other portions of the public hall through which it is necessary to pass when going from the entrance floor to the other floors of a building.
The same steps can be taken for joints D, H and E resulting in the complete Cremona diagram where the internal forces in all members are known. In a next phase the forces caused by wind must be considered. Wind will cause pressure on the upwind side of a roof (and truss) and suction on the downwind side. This will translate to asymmetrical ...
Cut the potato in half and let cool until easy enough to handle, about 5 minutes. Scoop out the flesh and mash in a medium bowl until smooth. Measure ½ cup mashed potato and reserve the rest for ...
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.