Search results
Results from the WOW.Com Content Network
The centre of buoyancy is at the centre of mass of the volume of water that the hull displaces. This point is referred to as B in naval architecture. The centre of gravity of the ship is commonly denoted as point G or CG. When a ship is at equilibrium, the centre of buoyancy is vertically in line with the centre of gravity of the ship. [1]
The ratio of the volume of a sphere to the volume of its circumscribed cylinder is 2:3, as was determined by Archimedes. The principal formulae derived in On the Sphere and Cylinder are those mentioned above: the surface area of the sphere, the volume of the contained ball, and surface area and volume of the cylinder.
In sailing and boating, a vessel's freeboard is the distance from the waterline to the upper deck level, measured at the lowest point of sheer where water can enter the boat or ship. [1] In commercial vessels, the latter criterion measured relative to the ship's load line , regardless of deck arrangements, is the mandated and regulated meaning.
The volume of a spherical cap with a curved base can be calculated by considering two spheres with radii and , separated by some distance , and for which their surfaces intersect at =. That is, the curvature of the base comes from sphere 2.
The generation of a bicylinder Calculating the volume of a bicylinder. A bicylinder generated by two cylinders with radius r has the volume =, and the surface area [1] [6] =.. The upper half of a bicylinder is the square case of a domical vault, a dome-shaped solid based on any convex polygon whose cross-sections are similar copies of the polygon, and analogous formulas calculating the volume ...
The bare term cylinder often refers to a solid cylinder with circular ends perpendicular to the axis, that is, a right circular cylinder, as shown in the figure. The cylindrical surface without the ends is called an open cylinder. The formulae for the surface area and the volume of a right circular cylinder have been known from early antiquity.
Used mainly to determine the minimum water depth for safe passage of a vessel and to calculate the vessel's displacement (obtained from ship's stability tables) so as to determine the mass of cargo on board. Draft, Air – Air Draft/Draught is the distance from the water line to the highest point on a ship (including antennas) while it is ...
The aforementioned volume of the cone is of the volume of the cylinder, thus the volume outside of the cone is the volume of the cylinder. Therefore the volume of the upper half of the sphere is of the volume of the cylinder. The volume of the cylinder is = = ("Base" is in units of area; "height" is in units of distance. Area × distance = volume.)