Ad
related to: 4-bit binary counter
Search results
Results from the WOW.Com Content Network
4-bit processors were widely used in electronic calculators and other roles where decimal math was used, like electronic cash registers, microwave oven timers, and so forth. This is because a 4-bit value holds a single binary coded decimal (BCD) digit, making it a natural size
A decade counter is a binary counter designed to count to 1001 (decimal 9). An ordinary four-stage counter can be easily modified to a decade counter by adding a NAND gate as in the schematic to the right. Notice that FF2 and FF4 provide the inputs to the NAND gate. The NAND gate outputs are connected to the CLR input of each of the FFs.". [1 ...
4-bit binary counter (separate divide-by-2 and divide-by-8 sections); different pinout for 74L93 14 SN74LS93: 74x94 1 4-bit shift register, dual asynchronous presets 16
40193 – Up/down binary counter with 4-bit binary preset. Decoders. 4028 – 4-bit BCD to 10-output decoder (can be used as 3-bit binary to 8-output decoder) 4511 – 4-bit BCD to 7-segment display decoder with 25 mA output drivers. Timers. 4047 – Monostable/astable multivibrator with external RC oscillator. 4060 – 14-bit ripple counter ...
The following is a list of CMOS 4000-series digital logic integrated circuits.In 1968, the original 4000-series was introduced by RCA.Although more recent parts are considerably faster, the 4000 devices operate over a wide power supply range (3V to 18V recommended range for "B" series) and are well suited to unregulated battery powered applications and interfacing with sensitive analogue ...
A binary counter can represent 2 N states, where N is the number of bits in the code, whereas a straight ring counter can represent only N states and a Johnson counter can represent only 2N states. This may be an important consideration in hardware implementations where registers are more expensive than combinational logic.
The counter itself must count in Gray code, or if the counter runs in binary then the output value from the counter must be reclocked after it has been converted to Gray code, because when a value is converted from binary to Gray code, [nb 1] it is possible that differences in the arrival times of the binary data bits into the binary-to-Gray ...
The reason for adding 6 is that there are 16 possible 4-bit BCD values (since 2 4 = 16), but only 10 values are valid (0000 through 1001). For example: 1001 + 1000 = 10001 9 + 8 = 17 10001 is the binary, not decimal, representation of the desired result, but the most significant 1 (the "carry") cannot fit in a 4-bit binary number.
Ad
related to: 4-bit binary counter