Search results
Results from the WOW.Com Content Network
On December 31, 2022, the National Institute of Standards and Technology, the National Geodetic Survey, and the United States Department of Commerce deprecated use of the US survey foot and recommended conversion to either the meter or the international foot (0.3048 m).
The National Institute of Standards and Technology formerly contended that customary area units are defined in terms of the square survey foot, not the square international foot, [17] but from 2023 it states that "although historically defined using the U.S. survey foot, the statute mile can be defined using either definition of the foot, as is ...
The US survey foot is defined so that 1 metre is exactly 39.37 inches, making the international foot of 0.3048 metres exactly two parts per million shorter. This is a difference of just over 3.2 mm, or a little more than one-eighth of an inch per mile.
These are the defining dimensions for NAD 27, but Clarke actually defined his 1866 spheroid as a = 20,926,062 British feet, b = 20,855,121 British feet. The conversion to meters uses Clarke's 1865 inch-meter ratio of 39.370432. The length of a foot or meter at the time could not practically be benchmarked to better than about 0.02 mm. [11]
These efforts are known as "High Accuracy Reference Network" (HARN) or "High Precision GPS Network" (HPGN). In addition, the basic unit of distance used is sometimes feet and sometimes meters. Thus a fully described coordinate system often looks something like: "Washington State Plane North, NAD83 HARN, US Survey feet".
The US Customary system of units was developed and used in the United States after the American Revolution, based on a subset of the English units used in the Thirteen Colonies; it is the predominant system of units in the United States and in U.S. territories (except for Puerto Rico and Guam, where the metric system, which was introduced when ...
Originally known as Sea Level Datum of 1929, NGVD 29 was determined and published by the United States Coast and Geodetic Survey [2] and used to measure the elevation of a point above and depression below mean sea level (MSL).
historical definitions of the units and their derivatives used in old measurements; e.g., international foot vs. US survey foot. For some purposes, conversions from one system of units to another are needed to be exact, without increasing or decreasing the precision of the expressed quantity. An adaptive conversion may not produce an exactly ...