Search results
Results from the WOW.Com Content Network
Drainage gradient (DG) is a term in road design, defined as the combined slope due to road surface cross slope (CS) and longitudinal slope (hilliness). Although the term may not be used, the concept is also used in roof design and landscape architecture. If the drainage gradient is too low, rain and melt water drainage will be insufficient.
Cross section of a road. 1. Gutter; 2. Shoulder; 3. Sub-base; 4. Base course; 5. Asphalt. Cross slope, cross fall or camber is a geometric feature of pavement surfaces: the transverse slope with respect to the horizon.
If one looks at red numbers on the chart specifying grade, one can see the quirkiness of using the grade to specify slope; the numbers go from 0 for flat, to 100% at 45 degrees, to infinity as it approaches vertical. Slope may still be expressed when the horizontal run is not known: the rise can be divided by the hypotenuse (the slope length).
Steeper cants or cambers are common on residential streets, allowing water to drain into the gutter. Cross slope describes the slope of a roadway perpendicular to the centerline. If a road were completely level, water would drain off it very slowly. This would create problems with hydroplaning, and ice accumulation in cold weather.
In modern mapping, a topographic map or topographic sheet is a type of map characterized by large-scale detail and quantitative representation of relief features, usually using contour lines (connecting points of equal elevation), but historically using a variety of methods.
A wide variety of river and stream channel types exist in limnology, the study of inland waters.All these can be divided into two groups by using the water-flow gradient as either low gradient channels for streams or rivers with less than two percent (2%) flow gradient, or high gradient channels for those with greater than a 2% gradient.
Pavement sloping: On straight sections of the highway, the roadway is to have a cross slope of at least 1.5%, and preferably 2% to ensure proper drainage, with up to 2.5% in areas of heavy rainfall. The cross slope of both the left and right shoulders should be between 2% and 6%, but not less than the main lanes.
Drainage density is a quantity used to describe physical parameters of a drainage basin. First described by Robert E. Horton , drainage density is defined as the total length of channel in a drainage basin divided by the total area, represented by the following equation: