Search results
Results from the WOW.Com Content Network
A rudder angle indicator is a device used to indicate the present position of the rudder blade, usually fitted near the Ship's wheel on the bridge and in the engine control room. [1] Rudder angle indicator of the MS Nordstjernen (1956) Rudder angle indicator
An inclinometer or clinometer is an instrument used for measuring angles of slope, elevation, or depression of an object with respect to gravity's direction. It is also known as a tilt indicator, tilt sensor, tilt meter, slope alert, slope gauge, gradient meter, gradiometer, level gauge, level meter, declinometer, and pitch & roll indicator.
In sailing, a boom is a spar (pole), along the foot of a fore and aft rigged sail, that greatly improves control of the angle and shape of the sail. The primary action of the boom is to keep the foot flatter when the sail angle is away from the centerline of the boat. The boom also serves as an attachment point for more sophisticated control lines.
The SLI measures the angle and extension of the boom along with the load weight and compares this with the manufacturer's specifications to determine if the lift is safe. [2] A safe load indicator has the capability of detecting the angle, weight of load lifted, and ground radius of any lifting device.
acute angle An angle that is smaller than a right angle, i.e. less than 90 degrees. See also obtuse angle. adhesion The tendency of dissimilar particles or surfaces to cling to one another (cohesion refers to the tendency of similar or identical particles/surfaces to cling to one another). The forces that cause adhesion and cohesion can be ...
A jibboom (also spelled jib-boom) is a spar used to extend the length of a bowsprit on sailing ships. [1] It can itself be extended further by a flying jib-boom. [1] The heel (i.e. rear and lower) end of the flying jib-boom is attached to the jib-boom, and the heel of the jib-boom to the bowsprit.
A shaft angle is the angle between the axes of two non-parallel gear shafts. In a pair of crossed helical gears, the shaft angle lies between the oppositely rotating portions of two shafts. This applies also in the case of worm gearing. In bevel gears, the shaft angle is the sum of the two pitch angles
A precision dial indicator, with a sensitivity of 0.01 mm and range of 10 mm. In various contexts of science, technology, and manufacturing (such as machining, fabricating, and additive manufacturing), an indicator is any of various instruments used to accurately measure small distances and angles, and amplify them to