Search results
Results from the WOW.Com Content Network
Voltage standing wave ratio (VSWR) (pronounced "vizwar" [1] [2]) is the ratio of maximum to minimum voltage on a transmission line . For example, a VSWR of 1.2 means a peak voltage 1.2 times the minimum voltage along that line, if the line is at least one half wavelength long.
A parameter often encountered in specification sheets for antennas that operate in certain environments is the ratio of gain of the antenna divided by the antenna temperature (or system temperature if a receiver is specified). This parameter is written as G/T, and has units of dB·K −1. G/T Calculation. G/T is the figure of merit for a ...
(dB) ≈ 36.6 dB + 20 log10[frequency (MHz)] + 20 log10[distance (miles)] These alternative forms can be derived by substituting wavelength with the ratio of propagation velocity ( c , approximately 3 × 10 8 m/s ) divided by frequency, and by inserting the proper conversion factors between km or miles and meters, and between MHz and (1/s).
The diodes convert the magnitudes of the forward and reverse waves to the terminals FWD and REV, respectively, as DC voltages, which are smoothed by the capacitors. [1]: 27‑21 The meter or amplifier (not shown) connected to the FWD and REV terminals acts as the required drain resistor, and determines the dwell-time of the meter reading.
It is usually expressed as a ratio in decibels (dB); = where RL(dB) is the return loss in dB, P i is the incident power and P r is the reflected power. Return loss is related to both standing wave ratio (SWR) and reflection coefficient (Γ). Increasing return loss corresponds to lower SWR.
The electric field strength at a specific point can be determined from the power delivered to the transmitting antenna, its geometry and radiation resistance. Consider the case of a center-fed half-wave dipole antenna in free space, where the total length L is equal to one half wavelength (λ/2).
Any component of the transmission line that has an input and output will contribute to the overall mismatch loss of the system. For example, in mixers mismatch loss occurs when there is an impedance mismatch between the RF port and IF port of the mixer [dubious – discuss]. [4]
The noise factor (a linear term) is more often expressed as the noise figure (in decibels) using the conversion: = The noise figure can also be seen as the decrease in signal-to-noise ratio (SNR) caused by passing a signal through a system if the original signal had a noise temperature of 290 K. This is a common way of expressing the noise ...