Search results
Results from the WOW.Com Content Network
A Kelvin bridge, also called a Kelvin double bridge and in some countries a Thomson bridge, is a measuring instrument used to measure unknown electrical resistors below 1 ohm. It is specifically designed to measure resistors that are constructed as four terminal resistors.
Oxygen arc cutting and arc welding underwater requires greater skill and stamina than working in a dry and stable environment. The underwater environment imposes several limitations and restrictions on both the equipment and the operator, and the restriction of short bottom times at greater depths for surface-oriented divers makes efficient working important to getting the job done in a ...
Arc-based cutting methods are used for cutting these materials. Among these, plasma arc cutting is the most commonly employed technique, owing to its precision and ability to cut through high-alloy steels efficiently. [1] Thermal cutting creates a shallow region contaminated material adjacent to the cut surfaces - the heat affected zone. For ...
Typical currents range from 0.1 amp per square mm to 5 amps per square mm. Thus, for a small plunge cut of a 1 by 1 mm tool with a slow cut, only 0.1 amps would be needed. However, for a higher feed rate over a larger area, more current would be used, just like any machining process—removing more material faster takes more power.
A thermal lance, thermic lance, oxygen lance, or burning bar is a tool that heats and melts steel in the presence of pressurized oxygen to create very high temperatures for cutting. It consists of a long steel tube packed with alloy steel rods, which serve as fuel; these are sometimes mixed with aluminum rods to increase the heat output.
The aluminum-cased types are designed to be attached to a heat sink to dissipate the heat; the rated power is dependent on being used with a suitable heat sink, e.g., a 50 W power rated resistor overheats at a fraction of the power dissipation if not used with a heat sink. Large wirewound resistors may be rated for 1,000 watts or more.
Forging temperature is the temperature at which a metal becomes substantially more soft, but is lower than the melting temperature, such that it can be reshaped by forging. [1]
Air carbon arc cutting, also referred to as metal arc gouging, and previously as air arc cutting, [1] is an arc cutting process where metal is cut and melted by the heat of a carbon arc. Molten metal is then removed by a blast of air. It employs a consumable carbon or graphite electrode to melt the material, which is then blown away by an air jet.