Search results
Results from the WOW.Com Content Network
Tri-Clamp Fittings [2] Tri-Clover Fittings [3] S-clamp fitting; Sanitary Fittings [4] 3A pipe fitting (This terminology includes other types of fittings. "3-A" is a set of standards for cleanability and inspection of dairy equipment, developed by 3-A Sanitary Standards, Inc. [5])
A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube (designated by actual size, with lower tolerance for variance), adapt to different sizes or shapes, and for other purposes such as regulating (or measuring) fluid flow. [1] [2] These fittings are ...
The most common plumbing fixtures are: Bathtubs; Bidets; Channel drains; Drinking fountains; Showers; Sinks; Tap (connections for water hoses) . Tapware - an industry term for that sub-category of plumbing fixtures consisting of tap valves, also called water taps (British English) or faucets (American English), and their accessories, such as water spouts and shower heads.
In 1884 Dr. Roger S. Tracy wrote "Hand-Book of Sanitary Information for Householders" which was published by D. Appleton and Company. The book contains "Facts and Suggestions about Ventilation, Drainage, Care of Contagious Diseases, Disinfection, Food, and Water". Dr. Tracy was the Sanitary Inspector of the New York City Health Department.
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
Fittings are also used to split or join a number of pipes together, and for other purposes. A broad variety of standardized pipe fittings are available; they are generally broken down into either a tee, an elbow, a branch, a reducer/enlarger, or a wye. Valves control fluid flow and regulate pressure.
AN fittings are a flare fitting, using 37° flared tubing to form a metal-to-metal seal. They are similar to other 37° flared fittings, such as JIC , which is their industrial variant. [ 2 ] The two are interchangeable in theory, though this is typically not recommended due to the exacting specifications and demands of the aerospace industry.