Search results
Results from the WOW.Com Content Network
A screw extractor held in a tap wrench. A screw extractor is a tool for removing broken or seized screws.There are two types: one has a spiral flute structure, commonly called an easy out after the trademarked name EZ-Out; [clarification needed] the other has a straight flute structure.
Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt.
A set of metric spanners or wrenches, open at one end and box/ring at the other. These are commonly known as “combination” spanners. A wrench or spanner is a tool used to provide grip and mechanical advantage in applying torque to turn objects—usually rotary fasteners, such as nuts and bolts—or keep them from turning.
A Kelly Tool in the NYC Fire Museum (2nd from left) The Kelly tool is a tool used in fire and rescue service for forcible entry and other prying and striking tasks. The predecessor of the Halligan bar, it has largely been superseded by the latter, but still sees some use.
A 1/2" drive pistol-grip air impact wrench. An impact wrench (also known as an impactor, impact gun, air wrench, air gun, rattle gun, torque gun, windy gun) is a socket wrench power tool designed to deliver high torque output with minimal exertion by the user, by storing energy in a rotating mass, then delivering it suddenly to the output shaft.
Multi-jackbolt tensioners (MJTs), registered under the trademark Superbolt or Supernut, are designed to decrease the torque required to tighten large bolted joints. One of the major problems associated with traditional bolt tightening methods is as the diameter of the bolt increases, the amount of torque required to tighten it increases in the third power of the diameter. [1]
The tool is simple, small and light. The contact surfaces of the screw or bolt are protected from external damage. There are six contact surfaces between bolt and driver. Very small bolt heads can be accommodated. The tool allows the use of headless and recessed-head screws. The screw can be held by the key while it is inserted into its hole.
The first outer leg is inserted into the lewis hole, followed by the second outer leg. The inner (parallel) leg is inserted last, pushing the outer legs into contact with the inside of the lewis hole. The shackle is unbolted, placed over the legs, and the bolt fastened through both the shackle eyes and the eye in the top of each leg.